Chapter 4: Hardware Assembly
Your InventorⅡ has been installed before leaving factory, you can start up the
InventorⅡ for printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
(4-1) The filament cartridge is at the rear of InventorⅡ. Lift the cartridge out of the
InventorⅡ.
(4-2) Take out the filament and thread it through the filament detecting equipment.
(Note: The filament should feed from the bottom of the spool towards the top )
After installing the filament, put the cartridge back to the printer.
InventorⅡ User Guide | www.flashforge.com
4-1
4-2
24
Black Filament Detecting
Equipment
400-699-1063