Konica Minolta bizhub 4020 Service Manual page 242

bizhub 4020/3320 Service Manual
Warning—Potential Damage: When opening or closing this type of actuator, gently lift the center of
the actuator using your finger. Do not use a fingernail or screwdriver to open the actuator. This could
damage the ribbon cable. Do not close the actuator from the ends of the actuator.
Removing a cable from the vertical mount contact connector
1. Gently rotate the locking actuator from the center of the actuator to the unlocked position.
2. Slide the cable out of the connector.
Inserting a cable into the vertical mount contact connector
1. When installing the cable, check the locking actuator to verify it is in the open position.
- 241 -