Input Tray Tests; Output Bin Tests - Konica Minolta bizhub 4020 Service Manual

5.1.8

INPUT TRAY TESTS

Feed Tests
This test feeds blank pages through the paper path. It can run using any of the paper or envelope sizes
supported by the printer.
To run the Feed test:
1. From the Diagnostics menu, navigate to:
Input Tray Tests >Feed Tests
2. Choose the input source. All installed sources appear.
3. Choose any of the following:
- Single—Feeds a single page.
- Continuous—Continuously feeds pages until X is pressed.
Sensor Test
Use this test to determine if the input tray sensors are working correctly.
1. From the Diagnostics menu, navigate to:
Input Tray Tests >Sensor Test
2. Select the input source. All installed sources appear.
Not all sensors appear for all trays. The following table indicates which tray sensors are available
for each input source:
Input source
Standard tray
Optional 250-/550-sheet tray
Multipurpose feeder
3. Manually actuate each sensor. The tray empty sensor can be actuated by hand; however, a sheet
of paper can be used to cover the pass through sensor.
4. Press X to exit the test.
5.1.9

OUTPUT BIN TESTS

Feed Tests
This test verifies that media can be fed to a specific output bin. No information is printed on the media.
bizhub 4020/3320 Service Manual
Tray empty sensor Pass through sensor
- 194 -