Ep Setup - Konica Minolta bizhub 4020 Service Manual

Printer default values
PPDS Code Page
Universal Units of Measure
To change this setting:
1. From the Diagnostics menu, navigate to:
Printer Setup >Defaults
2. Choose U.S. or Non-U.S.
3. Do one of the following:
- Depending on the printer model, press OK or touch
- Press X to return to the Printer setup menu.
Printed Page Count
The value of this setting gauges the amount of usage on the printer. The value of the Printed Page
Count setting will equal the values of the Picked Sides meter. After all print tests have been completed,
the value will reset to zero.
Note: The value of the setting cannot be changed manually.
Permanent Page Count
The value of this setting indicates the total amount of pages that have been printed. After all print tests
have been completed, the value will reset to zero.
Note: The Permanent Page Count value cannot be reset.
Engine Setting [x]
These settings are used by Engine code ECs to fix field problems. The value of [x] is any value from 1
to 16.
Edge to Edge
When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page
(printable area of a supported paper size). This feature does not work in PPDS emulation.

5.1.13 EP SETUP

EP Defaults
This setting restores each printer setting listed in EP SETUP to its factory default value. Sometimes this
is used to help correct print quality problems.
bizhub 4020/3320 Service Manual
US value
437
Inches
- 198 -
Non-US value
850
Millimeters
to save any changes.