Entering The Diagnostics Menu; Registration - Konica Minolta bizhub 4020 Service Manual

Diagnostics Menu
5.1.1

Entering the Diagnostics menu

1. Turn off the printer.
2. Press and hold 3 and 6.
3. Turn on the printer.
4. Release the buttons when the splash screen appears.
5.1.2

Registration

These settings adjust the margins of the black plane.
To set the Registration:
1. Print a Quick test page.
a. From the Diagnostics menu, navigate to:
Registration >Quick Test
b. Retain this page to determine the changes you need to make to the margin settings. The
alignment diamonds in the margins should touch the margins of the page.
The Quick test page contains the following information:

General printer information, including current page count, installed memory, processor
speed, serial number, engine ID, and system card ID

Printer margin settings

Printer revision levels

Alignment diamonds at the top, bottom, and each side

Horizontal lines for skew adjustment
2. Change the value of any of the margin settings.
Top Margin
Bottom Margin
Left Margin
Right Margin
bizhub 4020/3320 Service Manual
Intermediate Menu, Setting or
Operation
Scanner Calibration Reset
ADF Magnification (bizhub 4020 only)
FB Magnification (bizhub 4020 only)
-16 to +16 Increasing the value moves the image down the page. Always adjust
the top before the bottom margin.
-20 to +20 Increasing the value moves the image toward the top of the page.
-25 to +25 Increasing the value moves the image toward the right margin.
Always adjust the left before the right margin.
-30 to +30 Use this to adjust the printhead.
Values, Operation or Setting
Paper FB Long
(bizhub 4020 only)
Continue
Exit
Magnification
Magnification
- 187 -
0.98 - 1.015
0.98 - 1.015