Table of Contents
Advertisement
D*AP4 VAP
The routing example on the left hand side shows both mic inputs connected to the voice channel inputs
V1/V2
of the DSP. The analog input ANL1 / ANL2 is connected to the DSP program input while the DSP
voice channel outputs
DSP monitor output
Important Note! If a different optional interface board is installed the matrix will be expanded by the
pre-defined number of I/Os with their labels:
SDI
MADI
DANTE
4 Ch ANALOG I/O
AES
Mouse over
Setup GUI – AUDIO PROCESSOR - Overview
The overview shows the actual signal routing of the audio processor blocks, rendered by the DSPs.
The processing blocks in use, which may be activated from their individual setup panes, will be
indicated in green. I.e. blocks shown in grey are not activated by the user.
The order of the blocks depends on the setup of the audio processor (see next page).
To navigate through the various processing blocks you may either click on the graphical block or use
the tabs provided in the navigation bars below the bar graph displays.
V1/V2
are connected to the AES output and the DSP program output
L/R
are connected to the analog outputs ANL 1 ... ANL 4.
[O_DAP_SDI_a]
[O_DAP_MB_a /
O_MO_MM_a / _MS_a]
[O_DAP_DANTE_a]
[O_DAP_ADDA_a]
[O_DAP_AES_a]
Pls. see "Setup GUI – INTERFACES – SDI I/O interface – Local Routing"
for details.
DEM 1 ... DEM 16 and EMB 1... EMB 16
MDIN 1 ... MDIN 8 and MDOUT 1 ... MDOUT 8
DTIN 1 ... DTIN 8 and DTOUT 1 ... DTOUT 8
ANL 1 ... ANL 4 and ANL 1 ... ANL 4
AES 1 ... AES 8 and AES 1 ... AES 8
43
2L/2R
and the
Advertisement
Table of Contents
