Table of Contents
Advertisement
Setup GUI – INTERFACES – SDI I/O interface – Embedder
Delete Existing
Metadata
Stream Select
(SDID)
Video Line
Embedder Audio
Delay
Important Note! You must take care that for Dolby encoded signals the adjacent pairs must be set to the
same delay values not to destroy the data structure.
SDI OUT G1 CH1 (ms)
to
SDI OUT G4 CH16 (ms)
Audio Embedder
Delete Existing Data [ALL – New HANC Structure
Group 1 – 4 Mode [OFF / AUTO – Embedding
AES Channel
Status
Important note! If you generate a new AES channel
status the Audio Mode will be automatically set to Non
Audio (AKA "other") for both channels, if an adjacent pair
(1/2, 3/4 .....) carries a Dolby E stream for example.
VANC Metadata
Embedder
Enable
[AII / OFF]
[SDID 1 ... SDID 9]
[Auto / 9 ... 44]
The line number depends on the actual video standard how many VANC
lines are available for data insertion.
Each embedder signal may be delayed independently. This may be useful
for Lips Sync alignment if a video delay is used.
[0.0000 ... 340.000]
[0.0000 ... 340.000]
32
D*AP4 VAP
Here you set the general
functions of the embedder
/ OFF]
/ AUTO – Replace Audio
/ Delete]
See SDI I/O Interface > Overview
for details.
[Transparent / Professional]
If Professional these values are
used:
Format:
Professional
Audio Mode:
[Audio / Non
Audio]
Emphasis:
None
Freq. Mode:
Locked
Sample Freq.:
48kHz
Channel Mode:
Not Indicated
User Bits:
None
Auxiliary Bits:
24Bit
Audio Word
Length:
Not indicated
The embedder can insert one
Dolby metadata stream into the
Vertical Ancillary Data
[ON / OFF]
Advertisement
Table of Contents
