Getting Started - Ip Setup In General; Getting Started - Ip Setup - Via Console Interface - junger D*AP4 VAP Edition Manual

Getting Started – IP setup in general
The process of installing a D*AP4 VAP into an IP network is as follows:
1. Ask the system administrator for two unique IP addresses of the local area network,
for the netmask used and if a gateway address is necessary.
2. Assign the D*AP4 VAP an IP address
You have 2 choices to assign the D*AP4 VAP an IP address:
* From the serial console interface
* Via Web browser
3. Assign the X*AP RM
4. Attach the D*AP4 unit to the X*AP RM
Important Note! If you are not familiar with setting up devices for IP communication, we highly recommend
you consult your system service or IT department to assist you.
Getting Started – IP setup
The tool to change the IP configuration of the D*AP4 unit can be reached via the console interface. You must
connect it with the PC via an USB A to B cable. This will install the driver for the built in USB to serial
converter. Now you can open a terminal program. Here you must select the virtual COM port assigned by
the OS. The communication parameters are:
115200kBaud, 8, N, 1 no hand shake. Pressing <ENTER> will open the console menu:
Go for item 2:
"Your choice: 2"
"Current network configuration
IP Address:
Netmask ...:
Gateway ...:
You must enter the IP address and the netmask. Here is an an example:
Enter new IP address, press ENTER to cancel: "192.168.176.78"
Enter new netmask, press ENTER to cancel: "255.255.255.0"
remote panel a unique IP address configuration
1
1
via console interface
–
<ENTER>
10.110.88.1
255.255.0.0
10.110.0.1
remote panel
8
D*AP4 VAP
<Enter>
<Enter>