Table of Contents
Advertisement
D*AP4 VAP
System Latency:
Base Latency
AES IN to AES OUT
Mic IN to AES OUT
Additional Latencies
Spectral Signature
Dynamics Look Ahead
Limiter Look Ahead Long
Base latency consists of 1 ms Limiter Look Ahead Time and all system inherent
processing and input/output delays.
Activating sample rate converters will add additional latency (< 1ms).
Setup GUI – AUDIO PROCESSOR – Input
You may set the input conditions for both signal paths - voice (V1 / V2) and program (2L / 2R)
via the page embedded tab sheets. The layout of the embedded "Voice" pane differs depending on
the general setup (see SYSTEM > Setup > Voice Channel Mode):
Voice Channel Mode = "2 x Mono"
Link
Input
Mute
Input Gain (dB)
Polarity (voice input)
Mono (program input)
Input HPF (Hz)
Input LPF (Hz)
Input Delay Coarse (ms)
Input Delay Fine (samples) [0 ... 2000]
44.100kHz
48.000kHz
3,33
4,25
2,9
2
1
= "Stereo" (unlinked)
[Unlinked, Linked]
This function will only be available if the voice channel is set for
"Stereo" (see SYSTEM > Setup > Voice Channel Mode).
[Enable / Disable]
Enables or disables the input section
[ON / OFF]
[-80.0 ... 0.0 ... 20.0]
[Normal / Inverted]
[L/R Stereo / L+R Mono / L/L Mono / R/R Mono]
[OFF / 20 / 40 / 80 / 120]
[OFF / 15 / 20 / 22]
[0.0 ... 2000.0]
45
88.200kHz
96.000kHz
3,06
2,12
3,9
2,59
2,66
2,9
2
2
1
1
Program pane:
2,04
2,44
2,66
2
1
Advertisement
Table of Contents
