Setup Gui - Interfaces - Dante I/O Interface - Outputs; Setup Gui - Interfaces - Dante I/O Interface - Network - junger D*AP4 VAP Edition Manual

Channel
Connected
Status
Setup GUI – INTERFACES – Dante I/O Interface – Outputs
Setup GUI – INTERFACES – Dante I/O Interface – Network
Dante Redundancy
The labels assigned to that channel by the DanteController
The source of the audio signal.
[No Subscription / Subcription Unresolved / Wait / Naming Problem /
Loopback / Idle / Subscription in Progress / Connected (Unicast) /
Connected (Multicast) / Manual Config / Format Problem /
QoS Problem / Latency Problem / Clock Domain Problem /
Link Down / Fail / Unknown]
The DANTE module provides very detailed status information. In
regular operation one will not see much of it.
Outputs
Channel
Channel
Label
The DANTE interface allows redundant network operation.
Pls. refer to manufacturer's documentations of your Ethernet
equipment on supported switching configuration and redundant
operation.
38
D*AP4 VAP
The signals from the DANTE
board to the network. They will
also appear in the device
ROUTING section.
Numeric count of the channels.
Up to eight labels can be
configured for each stream from
the interface to the network. This
allows configuring multi layer
routing.