Table of Contents
Advertisement
D*AP4 VAP
Operating – menu structure of the X*AP RM
When pressing the <MENU> button, the upper operating display opens up:
Analog Mic
ON AIR
Interface
Profiles
When pressing the <ESC> button you will return to the main operating display.
Operating display – Analog Mic Interface
M1 Preamp
Gain Enable
Gain [dB]
on
10
Here you can setup both mic preamps.
Operating display – ON AIR profiles
Voice 1
Cough Cut
Voice Over
Mic Active
OFF
This is the same menu that you will reach if the feature set "Load Profiles" is selected
(see previous page). Here you may remote control the cough cut for the respective voice channel and
load a pre-defined profile. A profile is a set of audio relevant presets that must be set-up in the:
EVENTS > Events > Preset Events section. Pressing the <Load Profile> hotkey will highlight the area
above the button (see above – the default display is a dash). You can now select a profile by turning the
Rotary Encoder. After the selection you must press the Rotary Encoder or the <Load Profiles> hotkey.
Operating display – Loudness Meter
EBU R128
Integrated
[LUFS]
Input
-19.3
Output
-23.2
The meter style (ITU BS.1770-x / ATSC / EBU etc.) is defined by the settings of:
AUDIO PROCESOR > Level Magic > Loudness Mode (example is for EBU R12().
The above menu serves as a display of measurement values and offers the metering control buttons
(reset & pause / continue).
remote panel – operating displays
1
Voiceproc 3
ITU BS 1770-3
Meter
Voiceproc 3
Phantom
Power
Pad [dB]
off
OFF
Voiceproc 3
ON AIR
Load Profile
Radio Voice
LRA
Time
[LU]
hh:mm:ss
6.4
5.8
00:12:15
reset
pause
10.110.88.135
Audio Processor
Monitor
Voice
Program
10.110.88.135
M2 Preamp
Gain Enable
Gain [dB]
Pad [dB]
off
10
OFF
10.110.88.135
Short-Term
TPL Max
[dBTP]
Max
-19.7
-6.6
-12.0
-21.3
-5.0
-16.0
reset max
11
Monitor
1/2
3/4
Phantom
Power
off
Momentary
MENU
ESC
MENU
ESC
MENU
ESC
MENU
ESC
Advertisement
Table of Contents
