junger D*AP4 VAP Edition Manual page 43

D*AP4 VAP
Mode
Important Note! When set to switched mode, do
(same Ethernet switch) if it does not support STP (Spanning Tree Protocol). This is the case for most of
the off-the-shelf (office) switches. Doing so will cause a race condition where IP packets are circling around
from the external switch to the second Dante (switch) port and back via the first port. This will tear down
your network and may create a bunch of new "friends" in your facility.
Primary Address Setup
Network Status
DHCP – Automatic IP Config. [OFF / ON]
IP-Address
Netmask
DNS Server
Gateway
MAC Address
Secondary Address Setup
Network Status
DHCP – Automatic IP Config. [OFF / ON]
IP-Address
Netmask
DNS Server
Gateway
MAC Address
[Switched / Redundant]
Redundant – The interface will duplicate the audio traffic to both
Ethernet ports.
Switched – The second port behaves like a standard switch
port allowing daisy-chaining through the interface.
I.e. IP configuration is only available for Redundant
mode.
connect both ports to the same network
not
Setup of the primary network interface
[Offline / Connected + bandwidth]
Setup of the secondary network interface
[Offline / Connected + bandwidth]
[unknown / address]
39