Table of Contents
Advertisement
D*AP4 VAP
Current Sync Source Status
Source
Sample Rate
Show Detailed Status
Sync Source Information
System Clock
Sample Rate (kHz)
Fallback Sample Rate (kHz)
Sync Source Priority
Choice 1 – 4
Fallback on Sync Error:
AES Select
Accept SDI Generator
Important note! It is not possible to gen-lock the SDI generator. The generator will run on its own
internal 27MHz crystal clock.
Setup GUI – SYSTEM – Remote Access – X*AP Remote
The VAP is designed for multi user applications where users will frequently alternate.
Since the VAP has two fully loaded processing channels one may use it for two independent mics from
different sound booths. On the other hand the X*AP can control multiple VAPs one by one and a single VAP
may be controlled from multiple X*APs. This requires a flexible remote concept that allows you to recall pre-
set configurations from the X*AP panel or from the mobile UI. You can control pre-settings of the EVENTS
system via remote access from the X*AP remote panel or from a mobile UI on a tablet, a smart phone or
even via a browser session from any PC in the network.
To better understand the possibilities of these settings it is recommended to study the comprehensive
EVENTS system of the D*AP4 VAP.
shows the status of the 5 tier sync priority circuit
active sync source
measured sample rate
[ON / OFF]
If you enable the checkbox you will get this additional information:
[Follow Source / 44.1 / 48 / 88.2 / 96]
[44.1 / 48 / 88.2 / 96]
[OFF / Internal / Sync-In WCLK / Sync-In AES
{or Input AES 1/2 XLR or Input AES 1/2 BNC} / Interface 1 {SDI I/O
or AES I/O or non} / Sync-In Black Burst/Tri-Level]
Internal
If the selected sync source is not available the next source will be
selected. If none of the pre selected sync source is not available,
the source will fall back to the internal clock oscillator.
[OFF / Sync-In AES / Input AES 1/2 XLR]
[ON / OFF]
For rare application you may use the SDI generator (if an SDI I/O
interface is installed) as the sync source. In this case downstream
equipment must be synchronized to the D*AP4 VAP.
See INTERFACES > SDI I/O interface > Setup for details.
19
Advertisement
Table of Contents
