Setup Gui - Audio Processor - Monitor - junger D*AP4 VAP Edition Manual

D*AP4 VAP
Setup GUI – AUDIO PROCESSOR – Monitor
As seen on the AUDIO PROCESSOR > Overview page the D*AP4 VAP provides two monitor facilities
which may be connected to the function blocks of the audio processor (DSP).
For the example below (see SYSTEM > Setup) the VAP is in Voice Channel Mode = "Stereo".
The first monitor is connected to the Input section of the voice channels in Stereo [V1/V2 Stereo]
while the second monitor is connected to the Leveler output of the Program path in L+R Mono
[Program L+R Mono] (see AUDIO PROCESSOR > Overview):
The settings must be done on the Monitor pane:
Source
Section / Channel
Processing Block
Monitor Output
Mute
Attenuation (dB)
Delay Coarse (ms)
Delay Fine
(samples)
[V1/V2 Stereo / V1+V2 Mono / Program Stereo / Program L/L Mono
Program R/R Mono / Program L+R Mono]
Select here which processing
block should be monitored
[ON / OFF]
[-80.0 ... 0.0]
[0 ... 2000]
[0 ... 2000]
63