Table of Contents
Advertisement
3.5
Changing Settings
This section describes how to configure your Strata RX with
different settings, using the front panel Control Switch.
For a summary of what settings can be made with the front panel
Control Switch and which are made using the Configurator
software, see Section 3.7 on page 3-30.
Here are the tasks described:
Topic
Selecting a Preset
Controlling DC Power on
Coax
Strata RX Operator's Guide/Tech Ref Manual
Page
3-18
3-20
3-21
3-22
3-23
3-24
3-25
3-26
Routine Operation
3.5.1
Selecting a Preset
The Strata RX is designed to enable you to control operating
settings (through Presets) independently of your selection of
Channel and Frequency.
Presets The Strata RX can be preconfigured with up to 9
Presets. Each Preset contains most of the operating settings
needed to control the RX System, including:
•
digital or analog demodulation
•
digital or analog video and audio outputs
Presets must be preconfigured using the Strata RX Configurator
software. Once defined, the details of a Preset cannot be
changed from the RX front panel.
For information on configuring Presets, see the "Configurator
Reference" chapter of the Strata RX Technical Reference
Manual.
Channels and Frequencies In a standard RX System,
Channels and Frequencies are controlled separately from
Presets.
However, if desired the Presets can also be used to specify the
receive frequency. This "Frequencies-Locked-to-Presets" option
is factory enabled, and must be specified when you order your
radio. The assignment of Frequencies to Presets is made using
the RX Configurator, and cannot be changed from the RX front
panel.
For more information on this option and how to use it, see the
"Configurator Reference" chapter of the Strata RX Technical
Reference Manual.
Presets and Channels
•
When you change a Preset, the last Channel chosen
stays in effect.
3-18
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Strata RX and is the answer not in the manual?