Vislink Strata RX Technical Reference Manual page 168

Table C-2: Configurator Error Messages
Error Message Possible Cause
Cannot Change Required hardware
Operation Mode is not present - i.e.,
attempt to program
COFDM settings
when no COFDM
installed.
Configurator cannot
find installed
hardware.
RS-232 cable is
disconnected.
RS-232 cable is
defective.
Installed RX
hardware defective.
Strata RX Technical Reference Manual
Suggested
Action
Check configuration
and match to
installed hardware.
Turn off Strata
power, close the
configurator, then
turn on Strata power
and start
configurator.
Connect cable. Be
sure connectors on
both ends are fully
seated.
Replace cable.
Contact MRC.
Configurator Reference
Table C-2: Configurator Error Messages
Error Message Possible Cause
Unable to Retrieve Problem with RS-
[Setting] 232 communication.
OR
Unable to Load
[Setting]
RS-232 cable is
disconnected.
RS-232 cable is
defective.
Installed RX
hardware defective.
Configuration FIle Unable to read data
Corrupt stored in file chosen.
File damaged.
OR
Unable to Open
Configuration File
Problem with PC or
its disk drive.
Suggested
Action
Try again.
If error still appears,
turn off Strata power,
close the
configurator, then
turn on Strata power
and start
configurator.
Connect cable. Be
sure connectors on
both ends are fully
seated.
Replace cable.
Contact MRC.
Select a different
configuration file.
Re-create
configuration and
save it with a
different filename.
Contact your PC
service provider.
C-18