Checking Printing Mode - MUTOH Toucan Hybrid PJ-162-FE User Manual

Step 4 : After head cleaning, perform nozzle check printing again, and check the condition of the head.
Notes :
If the smearing or misprinting is not solved after performing cleaning one time, change
the purge mode to "powerful" then repeat the head cleaning.
If the smearing or misprinting is not solved after performing cleaning a few times, refer to
"Trouble shooting", and take appropriate measures.
If printing problems are not corrected by increasing purge mode to "powerful", clean off
the print head surface using a polynit wiper soaked in jetwash fluid then perform head
cleaning again.

5.6.10 Checking printing mode

When checking the present printing mode, follow the steps below.
Step 1 : Press the [ENTER] key of the operation panel.
The product will perform the following operations for three seconds.
No. Position
nd
1 2 line
rd
2 3 line
th
3 4 line
After displaying the printing mode is finished, the product shifts to the normal condition.
* CurrentSetup *
1 →
Condition
2 →
Interlace
3 →
Direction/n
Description
Displays the Printing condition
Displays the Interlace method
Displays the Printing direction and repeat times.
n: Repeat times
360 x 360
2 pass
UniDir/1
References
→ Printing quality menu
→ Interlace Setup menu
→ Printing direction method
→ Repeat times menu
202
User's Guide – Toucan Hybrid
AP-750, Rev. 1.1 –- 23/04/04