Preparing For A Job; Introduction; Connecting The Power Cable - MUTOH Toucan Hybrid PJ-162-FE User Manual

Important :

4.1 INTRODUCTION

The procedures needed before using the printer are explained below.

4.2 CONNECTING THE POWER CABLE

The connection procedure for the power cable is explained below.
Important :
Caution :
Be careful of the following when handling the power cable:
Notes :
If the power cable is damaged, contact one of the following locations.

4 PREPARING FOR A JOB

Please check the ink status while printing in flatbed. When error message "Ink
not filled" is displayed, IR lamp will power on, this can cause burning hazard.
With firmware versions, older than V 3.02 L, continually check ink level.
Because there will not be a message when bottles are almost empty.
Make sure that the distributed power cable is used. Using a different cable
may result in electric shock or fire.
Do not use a damaged power cable. Doing so may result in electric shock or
fire.
The disconnect device is the plug on the power supply cord.
Do not make any modifications to the power cable.
Do not place anything heavy on the power cable.
Do not bend, twist, or pull the cable.
Do not wire the cable near equipment that generates heat.
The shop where you bought your MUTOH printer
Nearest MUTOH local dealer
55
User's Guide – Toucan Hybrid
AP-750, Rev. 1.1 –- 23/04/04