Installation; Notes On Safety; General Instructions; Notes On The Mains Supply - DETEWE OpenCom 510 User Manual

Installation

Notes on Safety

The CE symbol on the product con-
firms that it meets the requirements
of the technical guidelines on user
safety and electromagnetic compat-
ibility valid at the time of approval.

General Instructions

Please note: This product may be
installed and serviced by qualified
personnel only. Opening the housing
and carrying out unauthorised re-
pairs may damage the product and
will invalidate the warranty.
DANGER! Hazardous volt-
ages inside the device!
The MPS+1-AC power supply units
may not be opened as this may lead
to exposure to hazardous voltages!
Defective power supply units must
be sent to the manufacturer for re-
pairs.
Always use the original packaging
when packing OpenCom 510 com-
ponents for transport or storage.
Installation
CAUTION!
Static charge can damage the
OpenCom 510. Before and during
work on the electrical compo-
nents of the OpenCom 510, dis-
charge any static electricity from
your body and the tools you are
using.
Notes on the Mains
Supply
The OpenCom 510 may be con-
nected only to mains sockets with a
protective earth conductor.
Install the OpenCom 510 only near
easily accessible, wall-mounted
mains sockets.
Always use a dedicated circuit with
10-ampère protection to supply the
19" frame (1-12 frame).
If the OpenCom 510 is being pow-
ered by two MPS+1-AC power sup-
ply units, each of the two units must
be plugged into its own mains
Notes on Safety
17