Table of Contents
Advertisement
Programming
Channel Setting Commands
The AXB-IRS4 channel settings listed in the following table set IR output channels. The AXB-
IRS4 can process up to two IR or serial device channel setting commands simultaneously. If more
than two device commands are sent simultaneously, only the first two devices receive the
commands. The AXB-IRS4 can also be controlled with older SX-DCU+ RS-232 protocols.
Channel Setting Commands
Channel Description
1-252
253
255
Send Commands
The send commands listed in the following table send software strings to the AMX system, and
they are interpreted into a command and performed. The AXB-IRS4 can store up to 24
simultaneous CH, CP, SP, CTON, and CTOF send commands. Each command is stored and
transmitted to the appropriate channel when it becomes available.
Send Commands
Command
CARON
CAROFF
AXB-IRS4 IR/Serial Interface (4 Ports)
Channel assignment for IR output.
Non-volatile data error. If IR memory is cleared, the lithium battery may need to be replaced.
Non-volatile data not present. Control commands are not loaded into the AXB-IRS4.
Description
Enable carrier to respond according to DIP switch settings on the front
panel.
Example:
SEND_COMMAND 1,'CARON'
Device 1 sends the carrier signal according to the DIP switch settings.
Disable carrier from responding until a CARON command is received. This
command overrides the DIP switch settings on the front panel.
Example:
SEND_COMMAND 1,'CAROFF'
Device 1 will not send a carrier signal.
Programming
11
Advertisement
Table of Contents
