Default Messages - GE 469 Instruction Manual

4 SETPOINTS
Õ
PATH: SETPOINTS S1 469 SETUP
n DEFAULT MESSAGES
n [ENTER] for more
After a period of inactivity, the 469 displays default messages. Between 1 and 20 default messages can be selected. Multi-
ple default messages automatically scan in sequence at a rate determined by the
DEFAULT MESSAGE CYCLE TIME
grammable messages can be created and displayed (Message Scratchpad). For example, the relay can alternately scan a
motor identification message, the current in each phase, and the hottest stator RTD. Default messages are shown in the
Õ×
469 SETUP

DEFAULT MESSAGES

Use the following procedure to add default messages:
1. Enter the correct passcode for the
passcode has already been entered or the passcode is "0", defeating the passcode security feature).
2. Move to the message to be added to the default message list using the
message can be any actual value or Message Scratchpad message.
3. Press . The message
ENTER
4. Press again while displayed to add the current message to the default message list.
ENTER
5. If the procedure was followed correctly, the following flash message will be displayed:
DEFAULT MESSAGE
HAS BEEN ADDED
6. To verify that the message was added, view the last message in the
Use the following procedure to remove default messages:
1. Enter the correct passcode for the
passcode has already been entered or unless the passcode is "0", defeating the passcode security feature).
2. Select the message to remove under the
3. When the default message to be removed is shown, press
DEFAULT MESSAGE
4. Press ENTER to remove the current message from the default message list.
5. If the procedure was followed correctly, the following flash message will be displayed:
DEFAULT MESSAGE
HAS BEEN REMOVED
GE Multilin
Courtesy of NationalSwitchgear.com
Õ×
DEFAULT MESSAGES
ð
ENTER
MOTOR STATUS:
ESCAPE Stopped
A:
ESCAPE
0
MESSAGE
ESCAPE MOTOR LOAD:
0.00 x FLA
MESSAGE
ESCAPE CURRENT UNBALANCE:
0%
MESSAGE
DATE: 01/01/1995
ESCAPE
TIME: 12:00:00
MESSAGE
MULTILIN 469 Motor
ESCAPE
Management Relay
MESSAGE
setpoint. Any actual value can be selected for default display; in addition, up to five user pro-
subgroup.
S1 469 SETUP
PRESS [ENTER] TO ADD DEFAULT MESSAGES
S1 469 SETUP
S1 469 SETUP
message.
469 Motor Management Relay
Range: N/A
Range: N/A
0 B:
Range: N/A
Range: N/A
Range: N/A
Range: N/A
Õ Õ
PASSCODE ENTER PASSCODE FOR ACCESS
MESSAGE
will be displayed for 5 seconds.
S1 469 SETUP
Õ Õ
PASSCODE ENTER PASSCODE FOR ACCESS
Õ×
DEFAULT MESSAGES
ENTER . The relay displays the
4.2 S1 469 SETUP
4.2.5 DEFAULT MESSAGES
Õ×
S1 469 SETUP PREFERENCES
setpoint (unless the
and keys. The selected
MESSAGE
Õ×
subgroup.
DEFAULT MESSAGES
setpoint (unless the
subgroup.
PRESS [ENTER] TO REMOVE
4
Õ
S1
4-9