Voltage Metering; Speed - GE 469 Instruction Manual

5 ACTUAL VALUES
Õ×
PATH: ACTUAL VALUES
n VOLTAGE METERING
n [ENTER] for more
Measured voltage parameters will be displayed here.
If no VT connection type is programmed for the
the following flash message will appear when an attempt is made to enter this group of messages.
THIS FEATURE NOT
PROGRAMMED
Õ×
PATH: ACTUAL VALUES
n SPEED
n [ENTER] for more
If the Tachometer function is assigned to one of the digital inputs, the tachometer readout may be viewed here.
If no digital input is configured as tachometer in
will appear when an attempt is made to enter this group of messages.
THIS FEATURE NOT
PROGRAMMED
GE Multilin
Courtesy of NationalSwitchgear.com
Õ×
A2 METERING DATA

VOLTAGE METERING

ð
Vab: 0
ENTER
ESCAPE Vca: 0
AVERAGE LINE
ESCAPE
VOLTAGE: 0 Volts
MESSAGE
Van: 0
ESCAPE
Vcn: 0 Volts
MESSAGE
AVERAGE PHASE
ESCAPE
VOLTAGE: 0 Volts
MESSAGE
SYSTEM FREQUENCY:
ESCAPE
0.00 Hz
MESSAGE
S2 SYSTEM SETUP
Õ×
A2 METERING DATA

SPEED

ð
TACHOMETER: 0 RPM
ENTER
ESCAPE
S3 DIGITAL INPUTS
469 Motor Management Relay
Range: 0 to 20000 V. Not seen if VT Connection is
Vbc: 0
programmed as None
Volts
Range: 0 to 20000 V. Not seen if VT Connection is
programmed as None
Range: 0 to 20000 V. Seen only if VT Connection is
Vbn: 0
programmed as Wye
Range: 0 to 20000 V. Seen only if VT Connection is
programmed as Wye
Range: 0.00, 20.00 to 120.00 Hz
Õ×
VOLTAGE SENSING
Range: 0 to 3600 RPM
Seen only if a Digital Input is configured as
Tachometer
Õ×
ASSIGNABLE INPUT1(4)
5.3 A2 METERING DATA
5.3.3 VOLTAGE METERING
Õ×
setpoint,
VT CONNECTION TYPE
5.3.4 SPEED
, the following flash message
5
5-11