GE 469 Instruction Manual page 17

2 INSTALLATION 2.1 MECHANICAL
2.1.3 INSTALLATION
The 469 case, alone or adjacent to another SR series unit, can be installed in the panel of a standard 19-inch rack (see the
diagram below for panel cutout dimensions). Provision must be made when mounting for the front door to swing open with-
out interference to, or from, adjacent equipment. Normally the 469 unit is mounted in its case when shipped from the fac-
tory, and should be removed before mounting the case in the supporting panel. Unit withdrawal is described in the next
section.
2
Double Cutout Panel
Single Cutout Panel
Figure 2–4: SINGLE AND DOUBLE 469 CUTOUT PANELS
After the mounting hole in the panel has been prepared, slide the 469 case into the panel from the front. Applying firm pres-
sure on the front to ensure the front bezel fits snugly against the front of the panel, bend out the pair of retaining tabs (to a
horizontal position) from each side of the case as shown below. The case is now securely mounted, ready for panel wiring.
If additional support is desired, the SR optional mounting kit may be ordered.
808704A1.CDR
Figure 2–5: BEND UP MOUNTING TABS
GE Multilin 469 Motor Management Relay 2-3
Courtesy of NationalSwitchgear.com