GE 469 Instruction Manual page 136

5.1 OVERVIEW
nn A4 ACTUAL VALUES
nn MAINTENANCE
ESCAPE
MESSAGE
nn A5 ACTUAL VALUES
nn EVENT RECORD
ESCAPE
MESSAGE
nn A6 ACTUAL VALUES
nn PRODUCT INFO
5
Measured values, maintenance and fault analysis information are accessed in Actual Value mode. Actual values may be
accessed via one of the following methods:
1. The front panel, using the keys and display.
2. The front program port and a portable computer running the 469PC software supplied with the relay.
3. The rear terminal RS485 port and a PLC/SCADA system running user-written software.
Any of these methods can be used to view the same information. A computer makes viewing much more convenient, since
many variables may be viewed at the same time. Actual value messages are organized into logical groups, or pages, for
easy reference. All actual value messages are illustrated and described in blocks throughout this chapter. All values shown
in these message illustrations assume that no inputs (besides control power) are connected to the 469.
In addition to the actual value messages, there are also diagnostic messages and flash messages that appear when cer-
tain conditions occur. Diagnostic messages are described in Section 5.8.1: Diagnostic Messages on page 5–25. Flash
messages are described in Section 5.8.2: Flash Messages on page 5–26.
5-2
Courtesy of NationalSwitchgear.com
ð n TRIP COUNTERS
ENTER
n [ENTER] for more
ESCAPE
n GENERAL COUNTERS
ESCAPE
n [ENTER] for more
MESSAGE
n TIMERS
ESCAPE
n [ENTER] for more
MESSAGE
ð n [ENTER] EVENT 01
ENTER
n [ENTER] for more
ESCAPE
n [ENTER] EVENT 02
ESCAPE
n [ENTER] for more
MESSAGE
↓
n [ENTER] EVENT 40
ESCAPE
n [ENTER] for more
MESSAGE
ð n 469 MODEL INFO.
ENTER
n [ENTER] for more
ESCAPE
n CALIBRATION INFO.
ESCAPE
n [ENTER] for more
MESSAGE
469 Motor Management Relay
5 ACTUAL VALUES
See page 5–19.
See page 5–20.
See page 5–21.
See page 5–22.
See page 5–24.
See page 5–24.
5.1.2 DESCRIPTION
GE Multilin