Unit Withdrawal And Insertion - GE 469 Instruction Manual

2.1 MECHANICAL
TURN OFF CONTROL POWER BEFORE DRAWING OUT OR RE-INSERTING THE RELAY TO PREVENT MAL-
OPERATION!
CAUTION
If an attempt is made to install a unit into a non-matching case, the mechanical key will prevent full inser-
tion of the unit. Do not apply strong force in the following step or damage may result.
2
CAUTION
To remove the unit from the case:
1. Open the cover by grasping the center of the right side and then pulling the cover, which will rotate about the hinges on
the left.
2. Release the locking latch, located below the locking handle, by pressing upward on the latch with the tip of a screw-
driver.
3. While holding the latch raised, grasp the locking handle in the center and pull firmly, rotating the handle up from the
bottom of the unit until movement ceases.
2-4
Courtesy of NationalSwitchgear.com
Figure 2–6: PRESS LATCH TO DISENGAGE HANDLE
Figure 2–7: ROTATE HANDLE TO STOP POSITION
469 Motor Management Relay
2 INSTALLATION

2.1.4 UNIT WITHDRAWAL AND INSERTION

GE Multilin