Download  Print this page

469pc Software Interface; Requirements - GE 469 Instruction Manual

Motor management relay.
Hide thumbs

Advertisement

3.2 469PC SOFTWARE INTERFACE

3.2469PC SOFTWARE INTERFACE
This chapter provides the necessary information to install and/or upgrade a previous installation of the 469PC software,
upgrade the relay firmware, and write/edit setpoint files. It should be noted that the 469PC software should only be used
with firmware versions 30D220A4.000, 30D220A8.000, 30D251A8.000 or later releases.
469PC is not compatible with Mods or any firmware versions prior to 220, and may cause errors if setpoints are edited. It
can be used to upgrade older versions of relay firmware, but all previously programmed setpoints will be erased. Ensure
that all setpoints are saved to a file before reprogramming the 469 firmware.
The following minimum requirements must be met for the 469PC software to properly operate on a computer.
Processor:
Memory:
3
Hard Drive:
O/S:
Windows 3.1 Users must ensure that SHARE.EXE is installed.
NOTE
469PC can be installed from either the GE Multilin Products CD or from the GE Multilin website at http://www.GEindus-
trial.com/multilin. If you are using legacy equipment without web access or a CD, 3.5" floppy disks can be ordered from the
factory.
3-4
Courtesy of NationalSwitchgear.com
minimum 486, Pentium or higher recommended
minimum 4 MB, 16 MB recommended
minimum 540 K of conventional memory
20 MB free space required before installation of software.
Windows 3.1, Windows 3.11 for Workgroups, Windows NT, or Windows 95/98.
469 Motor Management Relay
3 USER INTERFACES

3.2.1 REQUIREMENTS

GE Multilin

Advertisement

Table of Contents

   Also See for GE 469

   Related Manuals for GE 469

Comments to this Manuals

Symbols: 0
Latest comments: