Installation; Mechanical; Description - GE 469 Instruction Manual

2 INSTALLATION

2.1 MECHANICAL

2 INSTALLATION 2.1MECHANICAL

2.1.1 DESCRIPTION

The 469 is packaged in the standard GE Multilin SR series arrangement, which consists of a drawout unit and a companion
fixed case. The case provides mechanical protection to the unit and is used to make permanent connections to all external
equipment. The only electrical components mounted in the case are those required to connect the unit to the external wir-
ing. Connections in the case are fitted with mechanisms required to allow the safe removal of the relay unit from an ener-
gized panel (for example, automatic CT shorting). The unit is mechanically held in the case by pins on the locking handle
2
that cannot be fully lowered to the locked position until the electrical connections are completely mated. Any 469 can be
installed in any 469 case, except for custom manufactured units that are clearly identified as such on both case and unit,
and are equipped with an index pin keying mechanism to prevent incorrect pairings.
No special ventilation requirements need to be observed during the installation of the unit. The 469 can be cleaned with a
damp cloth.
Figure 2–1: DIMENSIONS
To prevent unauthorized removal of the drawout unit, a wire lead seal can be installed in the slot provided on the handle.
With this seal in place, the drawout unit cannot be removed. A passcode or setpoint access jumper can be used to prevent
entry of setpoints but allow monitoring of actual values. If access to the front panel controls must be restricted, a separate
seal can be installed on the cover to prevent it from being opened.
Hazard may result if the product is not used for its intended purpose.
WARNING
Figure 2–2: SEAL ON DRAWOUT UNIT
GE Multilin 469 Motor Management Relay 2-1
Courtesy of NationalSwitchgear.com