Set Alarms - LANDTEC GEM5000 Operating Manual

5K-MNL-GEM5000
Select the soft-key 'Filter' to filter the data by sample point ID, or specify before or after date. Press the
soft-key 'Exit' to exit the filter menu and return to the 'View Data' screen. The screen shown in Figure 23
will filter for the ID named "ANAW0001". All dates in the instruments history will be used because an
"After Date" and a "Before Date" is not specified 00/00/00.
4) Select the soft-key 'Delete' followed by the appropriate soft-key to delete a single
reading or all filtered readings. Press soft-key 'Cancel' to cancel the deletion request.
5) Select the soft-key 'Exit' to exit the view data screen.
7.4.4

Set alarms

This option enables the operator to define the conditions for which an
alarm will be triggered. These conditions apply to the general operation of
the instrument and are not ID specific. A summary of the alarm settings
can be found in 'Key 3 – Summary'.
1) Select the 'Menu' button on the front of the analyzer to display the 'Device Settings'
menu. Press the soft key to display 'Operation Settings'.
2) Select 'Key 4 – Set Alarms' and the following menu is displayed:
Page 74
—
Figure 23 Filter Data
—
Figure 24 Set Alarms
Copyright LANDTEC North America, Inc.
GEM5000 Gas Analyzer
V1.13