View Data - LANDTEC GEM5000 Operating Manual

GEM5000 gas analyzer
3) For more information about the Gas Check Menu please refer to section 9.0
– Calibration.
4) Select soft-key 'Exit' to exit operation settings and return to the main screen.
7.4.3

View data

This option enables the operator to view the readings collected and stored
on the instrument. Readings may be downloaded to the LANDTEC System
Gas Analyzer Manager (LSGAM) software if further analysis is required.
1) Select the 'Menu' button on the front of the analyzer to display the 'Device Settings'
menu. Press the soft-key to display 'Operation Settings'.
2) Select 'Key 3 – View Data' and the following screen is displayed:
Note: Depending upon your instrument
—
Figure 22 View Data shows a highlight over CO, H
3) Browse through the readings
analyzer. Once at a particular reading, s
show more detail for that reading.
LANDTEC
—
Figure 21 Gas Check
—
Figure 22 View Data
'
s configuration, there may be empty rows or different gases where
and H S.
2 2
by selecting 'Key 4 – Scroll left' and 'Key 6 – Scroll right' on the
elect 'Key 2 – Page up' and 'Key 8 – Page down' to
5K-MNL-GEM5000
Page 73