Set Alarms - LANDTEC GEM5000 Operating Manual

OMGEM5KN4.7.1
3) Toggle through the reading by selecting 'Key 4 – Scroll left' and 'Key 6 – Scroll right'
on the analyzer. Select 'Key 2 – Page up' and 'Key 8 – Page down' to page through
the auxiliary channels listed.
4) Select the soft-key 'Filter' to filter the data by sample point ID, or specify before or
after date. Press the soft-key 'Exit' to exit the filter menu and return to the 'View
Data' screen.
5) Select the soft-key 'Delete' followed by the appropriate soft-key to delete a single
reading or all filtered readings. Press soft-key 'Cancel' to cancel the deletion request.
6) Select the soft-key 'Exit' to exit the view data screen.

7.2.4 Set alarms

This option enables the operator to define the conditions for which an
alarm/target will be triggered. These conditions apply to the general
operation of the instrument and are not ID specific. A summary of the alarm
settings can be found in 'Key 3 – Summary'.
Types of alarms
Common Alarms – Are non-ID specific alarms which apply to all the readings taken
with the analyzer.
ID specific alarms – Are ID specific, i.e. they will only trigger when a certain Id is
being used.
Tuning/targets – You can also set targets for your gas channels; these will highlight
gas channels green as oppose to when they alarm (yellow). These can be common or
ID specific.
Setting up alarms/targets
1) Select the 'Menu' button on the front of the analyzer to display the 'Device Settings'
menu. Press the soft key to display 'Operation Settings'.
Page 24 of 70
GEM5000 Gas Analyzer