GEM5000 gas analyzer
5K-MNL-GEM5000
Note: When using the Creating a new project from the data in the instrument option, only IDs NOT
associated with other projects will be created into the new project.
Creating a Device ID that does not measure flow Example- Probe or Sample Port
If there is no flow device you can choose the "No Flow (GA Mode)" option. Alternatively, you can also
choose User Input. When choosing the User Input option you will need to enter the appropriate pipe inside
diameter. A pump run-time must be specified in with either type of flow device.
Figure 8--Probe Definition using "No Flow" option
Figure 9--Probe Definition using "User
Input"
5.7.6 Creating your Site Questions
Site questions are setup in the same manner as ID questions however unlike ID questions, the answers
for Site questions will apply to all subsequent readings until the site question is updated. A total of 5 site
questions can be sent to your instrument. These must be updated each time you use the GEM. This is
The options for questions are Alphanumeric – Numeric – Multiple or Single comment selection.
LANDTEC
Page 37