4
Cabling a fiber optic module
Remove a fiber optic module from an SFP slot.
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a metal surface
2. Disconnect the fiber cable connector from the port connector.
3. Pull the fiber optic module out of the port by pulling the bail latch forward, away from the front
1
Bail latch
4. Grasping the bail latch, pull the fiber optic module out of the port.
5. Store the fiber optic module in a safe, static-free place or in an anti-static bag.
6. Install a new fiber optic module in the port. For information about performing this task, refer to
Installing a new fiber optic module
For instruction on installing a fiber optic module refer to
page 35.
Cabling a fiber optic module
For instruction on cabling a fiber optic module refer to
Cleaning the fiber-optic connectors
For instruction on cleaning a fiber optic module refer to
page 37.
46
DRAFT: BROCADE CONFIDENTIAL
(such as an equipment rack).
panel of the module. This unlocks the module from the front panel.
1
NOTE
The bail latch may be attached to either the top or the bottom of the mini-GBIC.
"Installing a new fiber optic
module".
"Installing a fiber optic module"
"Cabling a fiber optic module"
"Cleaning the fiber-optic connectors"
Brocade FastIron WS Hardware Installation Guide
on
on page 36.
on
53-1002188-01