Cabling A Fiber Optic Module - Brocade Communications Systems NetIron CES Series Hardware Manual

5
Fiber optic module replacement
CAUTION
All fiber-optic interfaces use Class 1 Lasers.
CAUTION
For safety reasons, the ESD wrist strap should contain a series 1 Meg ohm resistor.
Perform the following tasks to install a fiber optic module.
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a metal surface
2. Remove the new module from its protective packaging.
3. Gently insert the fiber optic module into the port until the module clicks into place. The module

Cabling a fiber optic module

Follow the steps given below to cable a fiber optic module
1. Remove the protective covering from the fiber-optic port connectors and store the covering for
2. Before cabling a fiber optic module, Brocade strongly recommends cleaning the cable
3. Gently insert the cable connectors (a tab on each connector should face upward) into the port
4. Observe the link and active LEDs to determine if the network connections are functioning
DANGER
The intra-building ports of the equipment or subassembly is suitable for connection to
intra-building or unexposed wiring or cabling only. The intra-building ports of the equipment or
subassembly MUST NOT be metallically connected to interfaces that connect to the OSP or its
wiring. These interfaces are designed for use as intra-building interfaces only (Type 2 or Type 4
ports as described in GR-1089-CORE, Issue 4) and require isolation from the exposed OSP
cabling. The addition of Primary Protectors is not sufficient protection in order to connect these
interfaces metallically to OSP wiring.
Tunable 10 GbE DWDM SFP+
NOTE
Tunable 10 GbE DWDM SFP+ are only supported on NetIron CES and NetIron CER 4x10G models
only.
72
(such as an equipment rack) to act as ground.
is keyed to prevent incorrect insertion.
future use.
connectors and the port connectors. Refer to
connectors until the tabs lock into place.
properly.
"Fiber optic connector cleaning"
Brocade NetIron CES and Brocade NetIron CER Hardware Guide
on page 73.
53-0000080-03