Redundant Power Supply Installation; Installing An Ac Power Supply - Brocade Communications Systems NetIron CES Series Hardware Manual

Redundant power supply installation

The Brocade device ships with one alternating-current (AC) power supply or direct-current (DC)
power supply. All models have two power supply slots, enabling you to install a second power supply
for redundancy. If desired, you can install a second supply for redundancy.
CAUTION
Changes or modifications made to this device that are not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
If you need to install a redundant power supply, it may be easier to install it before mounting the
device, although the power supplies are "hot swappable" and can be installed or removed after the
device is mounted and powered on.
This section provides the following procedures:
•
•

Installing an AC power supply

DANGER
Before beginning the installation, refer to the precautions in
Use the following procedures for AC power supplies in Brocade NetIron CES, Brocade NetIron CER
2000 series devices.
Brocade NetIron CES and Brocade NetIron CER Hardware Guide
53-0000080-03
Installing a redundant AC power supply –
Installing a redundant DC power supply –
Redundant power supply installation
"Installing an AC power supply"
"Installing a DC power supply"
"Power precautions"
3
on page 33
on page 35
on page 30.
33