Table of Contents
Advertisement
Installing a FastIron Compact Switch
Installing a redundant power supply
Installation location
Before installing the device, plan its location and orientation relative to other devices and equipment. Allow at least 3 inches of space at the
front of the device for the twisted-pair, fiber-optic, and power cabling. Also, allow a minimum of 3 inches of space between the sides and
the back of the device and walls or other obstructions.
Installing a redundant power supply
The FastIron Compact device ships with one AC or DC power supply. If desired, you can install a second supply for redundancy. For
more information about power supply redundancy, refer to
If you need to install a redundant power supply, it may be easier to install it before mounting the device, although the power supplies are
"hot swappable" and can be installed or removed after the device is mounted and powered on.
This section provides the following procedures:
•
Installing a redundant AC power supply –
•
Installing a redundant DC power supply –
Installing an AC power supply
Before beginning the installation, refer to the precautions in
Use the following procedures for AC power supplies in FastIron compact devices. Refer to
power supplies are supported in each device, and for illustrations showing power supply placement in the Brocade devices.
To install an AC power supply, complete the following steps.
1.
If necessary, remove the power supply locking screw located in the center rear of the device (illustrated below).
2.
If the empty power supply bay has a cover plate, press inward on the two latches near the edges of the cover plate to unlock the
plate, then remove the plate.
3.
Remove the power supply from its packaging.
4.
With one hand, hold the bar on the front panel of the power supply. With the other hand, support the underside of the power
supply, and insert the power supply into the empty power supply slot. Press until the supply is completely in the slot, so that the
connectors on the back of the supply are fully engaged with the pins on the power backplane.
30
"About redundant power supplies and power supply failure"
"Installing an AC power supply"
"Installing a DC power supply"
Power Supply locking screw
on page 30
on page 31
"Power precautions"
"Power supplies"
on page 21 for a list of which
Brocade FastIron Edge X-Series Hardware Installation Guide
Part Number: 53-1002499-02
on page 23.
on page 27.
Advertisement
Table of Contents
Troubleshooting
