3-53 ENGINE
• Install the primary drive gear
primary drive gear nut
NOTE:
This nut
• Tighten the primary drive gear nut to the specified
torque using the special tool.
09930-44913: Rotor holder
Primary drive gear nut :
100 N-m (10.0 kg-m, 72.5 Ib-ft)
BALANCER SHAFT BOLT
• Apply a small quantity of THREAD LOCK "1342" to the
balancer shaft bolt.
99000-32050: THREAD LOCK "1342"
• Tighten the balancer shaft bolt to the specified torque
using the special tool.
09930-44913: Rotor holder
bolt: 39 N-m (3.9 kg-m, 28.0 Ib-ft)
GEARSHIFT CAM DRIVEN GEAR
• Install each pawl into the gearshift cam driven gear.
Gearshift pawl
Pin
Spring
driven gear
NOTE:
The large shoulder must face to the outside.
• Apply a small quantity of THREAD LOCK "1303" to the
gearshift shaft stopper
99000-32030: THREAD LOCK SUPER "1303"
• Tighten the gearshift shaft stopper to the
specified torque.
Gearshift cam stopper: 19 N-m (1.9 kg-m, 13.5 Ib-ft)
Downloaded from
www.Manualslib.com
, wave washer
has left hand threads.
Gearshift cam
manuals search engine
and
Balancer shaft