Suzuki GZ250 Marauder Service Manual page 30

REAR BRAKE PEDAL HEIGHT
• Loosen the lock nut
• Adjust the brake pedal height
to locate the pedal 50 mm (2.0 in) above the top face
of the footrest.
REAR BRAKE ADJUSTING
• Adjust the free travel
turning the adjusting nut
REAR BRAKE SHOE WEAR
This motorcycle is equipped with brake lining wear limit
indicator on the rear brake.
To check brake lining wear, perform the following steps.
• Make sure that the rear brake is properly adjusted.
• Depress the rear brake pedal. Make sure that the index
mark is within the range
panel.
• If the index mark goes beyond the range, the brake shoe
assembly should be replaced with a new set of shoes.
BRAKE LIGHT SWITCH
Adjust the rear brake light switch so that the brake light will
come on just before pressure is felt when the brake pedal
is depressed.
Downloaded from www.Manualslib.com
by turning the adjuster
to 20-30 mm (0.8-1.2 in) by
embossed on the brake
manuals search engine
PERIODIC MAINTENA NCE
The extension line of the index mark is within
the range.
The extension line of the index mark is out of
the ranae.
2-14