Inspection - Suzuki GZ250 Marauder Service Manual

INSPECTION

IGNITION COIL PRIMARY PEAK VOLTAGE
• Remove the front seat. (See p. 5-1.)
• Remove the fuel tank. (See p. 4-1.)
• Disconnect the spark plug cap.
• Connect new spark plug to the spark plug cap and
ground it to the cylinder head.
NOTE:
Make sure that the spark plug cap and spark plug is con-
nected properly and the battery Is fully-charged.
Measure ignition coil primary peak voltage in the following
procedure.
• Connect the multi circuit tester with the peak volt adaptor
as follows.
Probe: White lead wire connector
Probe: Ground
NOTE:
Do not disconnect the ignition coil primary wire.
09900-25008: Multi circuit tester set
A CAUTION
When using the multi circuit tester and peak volt
adaptor, refer to the appropriate instruction manual.
• Shift the transmission into neutral, turn the ignition
switch to the "ON" position and grasp the clutch lever.
• Press the starter button and allow the engine to crank for
a few seconds, and then measure the Ignition coll prima-
ry peak voltage.
• Repeat the above procedure a few times and measure
the highest ignition coil primary peak voltage.
Tester knob indication: Voltage (
Ignition coil primary peak voltage: More than
200 V
AWARNING
While testing, do not touch the tester probes and
spark plug to prevent receiving an electric shock.
If the voltage is lower than the standard value, inspect the
ignition coil and the pick-up coil. (See pp. 6-21 to -23.)
Downloaded from www.Manualslib.com manuals search engine
Ignitor
)
ELECTRI C AL SYSTEM 6-20
Peak volt adaptor
Ignition
coil
New
spark
plug
Battery