Suzuki GZ250 Marauder Service Manual page 186

6-23 ELECTRICAL SYSTEM
• Remove the front seat. (See p. 5-1.)
• Remove the fuel tank. (See p. 4-1.)
• Disconnect the pick-up coil coupler and connect the mul-
ti circuit tester with the peak volt adaptor.
Probe: Green lead wire
Probe: Blue lead wire
• Measure the pick-up coil peak voltage in the same man
ner as on the ignitor coupler.
Tester knob indication: Voltage
Pick-up coil peak voltage: More than 5.0 V (Green-Blue)
If the peak voltage on the pick-up coil lead wire coupler is
ok but on the ignitor coupler is out of specification, the wire
harness must be replaced. If both peak voltages are out of
specification, the generator must be replaced and re-
checked.
PICK-UP COIL RESISTANCE
• Remove the seat and fuel tank and disconnect the pick-
up coil coupler.
• Measure the resistance between the lead wires and
ground. If the resistance is not within the specified value,
the generator stator must be replaced.
Pick-up coil resistance: 400-650 (Blue-Green)
Downloaded from www.Manualslib.com
(Blue-Ground)
manuals search engine
Pick-up
coil
coupler
Generator
Pick-up
coil
coupler
Generator
Peak volt
adaptor