Suzuki GZ250 Marauder Service Manual page 185

PICK-UP COIL PEAK VOLTAGE
• Remove the front seat. (See p. 5-1.)
• Remove the luggage box.
NOTE:
Be sure that all of the couplers are connected properly and
the battery is fully-charged.
• Disconnect the ignitor coupler at the ¡gnitor.
• Measure the pick-up coil peak voltage between the
Green and Blue lead wires on the ignitor coupler.
• Connect the multi circuit tester with the peak volt adaptor
as follows.
Probe: Green lead wire
Probe: Blue lead wire
09900-25008: Multi circuit tester set
A CAUTION
When using the multi circuit tester and peak volt
adaptor, refer to the appropriate instruction manual.
• Shift the transmission into neutral, turn the ignition
switch to the "ON" position and grasp the clutch lever.
• Press the starter button and allow the engine to crank for
a few seconds, and then measure the pick-up coil peak
voltage.
• Repeat the above procedure a few times and measure
the highest pick-up coil peak voltage.
Tester knob indication: Voltage (
Pick-up coil peak voltage: More than 5.0 V (Green-Blue)
If the peak voltage measured on the ignitor coupler is lower
than the standard value, measure the peak voltage on the
pick-up coil coupler as follows.
Downloaded from www.Manualslib.com manuals search engine
Generator
)
ELECTRICAL SYSTEM 6-22
Ignitor
Pick-up
coupler
coil
coupler
Peak
volt
adaptor