Changing The Frequency Of Remote Control Signal; About The Remote Control Signal - Christie DWU1052 User Manual

Changing the frequency of remote control signal

The accessory remote control has the two choices on signal frequency Mode
1:NORMAL and Mode 2:HIGH. If the remote control does not function properly,
attempt to change the signal frequency.
To set the Mode, press the combination of two buttons listed below simultaneously
for about three seconds.
(1) S et to Mode 1:NORMAL
SHUTTER and
MY BUTTON-4 buttons
(2) S et to Mode 2:HIGH
LENS SHIFT and
MY BUTTON-1 buttons
The REMOTE FREQ. in the
SERVICE item of the OPTION menu (90) of the projector to be controlled
should be set to the same mode as the remote control.

About the remote control signal

The remote control works with the
projector's remote sensor. This projector
has two remote sensors on the front and
back sides.
The sensors can sense signals within
the following range:
60 degrees (30 degrees to the left and right of the
sensor) within 3 meters about.
NOTE
• You can deactivate one of the sensors using the REMOTE RECEIV.
item in the SERVICE menu of the OPTION menu (90) .
• The remote control signal refl ected in the screen may be available. If it is
diffi cult to send the signal to the sensor directly, try to make the signal refl ect.
• The remote control uses infrared light to send signals to the projector (Class 1
LED), use the remote control in an area free from obstacles that could block the
remote control's signal to the projector.
• The remote control may not work correctly if strong light (such as direct
sun light) or light from an extremely close range (such as from an inverter
fl uorescent lamp) shines on the remote sensor of the projector. Adjust the
position of projector avoiding those lights.
• The projector cannot receive a remote signal from the connected equipment
using HDBaseT™, while the projector is receiving a signal directly from the
projector's remote sensor.
• The projector cannot receive a remote signal from the connected equipment
using HDBaseT right after turning the power on.
DWU1052/DHD1052
User's Manual - Operating Guide
(2)
LENS SHIFT
button
MY
BUTTON-1
button
3m
30° 30°
23
Remote control
(1)
SHUTTER
button
MY
BUTTON-4
button
30° 30°
3m
(approx.)
020-000854-01 Rev. 1 (12-2015)
LIT MAN USR DWU/DHD1052