Throttle Control; Shift Lever - Arctic Cat 700 DIESEL 2015 Service Manual

Throttle Control

REMOVING
1. Remove the two machine screws securing the throt-
tle control to the handlebar.
2. Slide the grommet out of the lower half of the throt-
tle control; then remove the cable from the actuator
arm.
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control lever.
4. Remove the actuator arm and account for a bushing.
Note the position of the return spring for installing
purposes.
INSTALLING
1. Place the return spring into the throttle control; then
place the bushing and actuator arm into position.
Secure with the cap screw, lock washer, and washer.
2. Using a pair of needle-nose pliers, place the spring
into position on the actuator arm.
AF676D
3. Place the two halves of the throttle control onto the
handlebars and secure with the two machine screws.
ADJUSTING
To adjust throttle cable free-play, see Periodic Mainte-
nance/Tune-Up.
AF677D
REMOVING
1. Remove the left-side splash panel.
2. Remove the E-clip securing the shift rod to the shift
lever.
3. Remove the axle and nut securing the shift lever to
the upper shift arm; then remove the shift lever.
Account for a spring and two O-rings.
INSTALLING
1. Place the spring into position between the upper shift
arm and shift lever; then making sure the O-rings are
in place on the axle, secure the shift lever to the arm
AF678D
with the existing axle and nut.
2. Place the shift rod into position on the shift lever and
secure with the existing E-clip.

Shift Lever

AF679D
AF680D
23