Arctic Cat 700 DIESEL 2015 Service Manual page 56

 NOTE: The valve cover has two "tamper-proof"
torx-head cap screws that can be removed by using
Torx-Head Screwdriver - #30.
4. Rotate the engine clockwise until either cylinder is at
TDC as shown in the following illustration.
5. Using an appropriate thickness gauge, check the
clearance between the camshaft follower and cam-
shaft.
6. To adjust the clearance, loosen the jam nut (A); then
rotate the adjuster (B) to obtain the specified clear-
ance (C).
54
DE405B
7. When proper clearance is attained, tighten the jam
nut (A) while holding the adjuster (B); then tighten
the jam nut securely and check clearance (C).
8. Rotate the crankshaft clockwise 180° and repeat
steps 5-7 on the other cylinder.

If engine is being assembled, static injector timing
should be adjusted (see Top-Side Components in this
section).
9. Place a small bead of high-temperature sealant on the fuel
rail seal; then carefully install the valve cover with a new
gasket and oil return boot. Using a crisscross pattern,
tighten the Allen-head cap screws to 6.5 ft-lb; then tighten
the two "tamper-proof" torx-head cap screws to 6.5 ft-lb.
DE557A
DE642A
10. Connect the oil pressure switch connector and the
crankcase ventilator hose; then install the air filter
assembly and secure with the existing hardware.
Tighten securely.
AT THIS POINT
DE429A
DE406
DE405B