Arctic Cat 700 DIESEL 2015 Service Manual page 22

8. Remove the cotter pins and slotted nuts from the
inner and outer tie rod ends; then remove the tie rods
from the steering post arm and the left-side and right-
side steering knuckles.
9. Remove two cap screws securing the lower steering
post bearing flange to the frame; then remove the
steering post.
20
CLEANING AND INSPECTING
1. Wash the tie rod ends in parts-cleaning solvent. Dry
with compressed air. Inspect the pivot area for wear.
Apply a low-temperature grease to the ends.
Always wear safety glasses when using compressed
air.
2. Inspect the tie rods for damaged threads or wear.
3. Inspect the tie rods for cracks or unusual bends.
4. Inspect all welded areas for cracks or deterioration.
CD685
5. Inspect the steering post and steering-post brackets
for cracks, bends, or wear.
6. Inspect the bearing halves, bearing caps, and bearing
housings for cracks or wear.
7. Inspect the handlebar tube for cracks, wear, or
unusual bends.
8. Inspect the handlebar grips for damage or wear.
INSTALLING
1. Place the steering post into position; then secure the
lower bearing flange to the frame with two cap
screws. Tighten to 20 ft-lb.
AF778D
2. Place the upper steering post bearings into the hous-
ings; then position on the steering post and secure the
housings to the frame with two cap screws. Tighten
to 20 ft-lb.
KX039
3. Install the tie rods and secure with the slotted nuts.
Tighten to 35 ft-lb; then install new cotter pins.
AL600D
! WARNING
AL600D
CD760