Arctic Cat 700 DIESEL 2015 Service Manual page 75

8. From the right side, remove the cap screws securing
the transmission halves together; then lay the trans-
mission on a suitable bench with the right side down.
9. Using a rubber mallet, lightly tap the left-side gear case
away from the right-side gear case leaving all components
in the right side. Account for any washers that may stick
to the left-side gear case and return to the proper shafts.
 NOTE: For steps 10-15, refer to illustration DE663B.
DE126A
10. Remove the output driveshaft assembly (A). Account
for the bearing alignment C-ring in the bearing boss
next to the output driven bevel gear.
 NOTE: Note the location of the bearing alignment
pin on the front output driveshaft bearing.
DE130A
11. Remove the shift fork shaft (B); then remove the
high/low shift fork.
12. Remove the shift shaft (C) and account for a spacer
and washer.
DE132
13. Remove the low/reverse shift fork; then remove the
input driveshaft (D).
 NOTE: The shift forks are identical; therefore, they
may be used in either location. However, it is advis-
able to return mating parts to their original positions
during assembling.
DE663A
DE663B
DE663D
DE677A
73