Arctic Cat 700 DIESEL 2015 Service Manual page 128

14. Using a T-30 torx wrench, remove the three screws
securing the front drive actuator to the gear case;
then remove the actuator.
15. Remove the differential mounting cap screws.
Account for the washers and discard the nuts.
16. Free the differential assembly from the frame mount-
ings; then shift the differential assembly forward enough
to disengage the front driveshaft from the output yoke.
17. Place the differential on its right side; then remove it
from the frame.
Disassembling Input Shaft
 NOTE: This procedure can be performed on a rear
gear case; however, some components may vary
from model to model. The technician should use dis-
cretion and sound judgment.
1. Using a T-40 torx wrench, remove the cap screws
securing the pinion housing.
126
2. Using a rubber mallet, remove the housing. Account
for a gasket. Remove the fork, collar, and spring.
Note the location of all the components for assem-
CF650
bling purposes.
CF650A
3. Using a boot-clamp pliers (or suitable substitute),
remove the boot clamps; then remove the boots and
splined drive from the input shaft.
4. Remove the input shaft from the pinion housing.
KX161
GC004A
GC015
CD106