Arctic Cat 700 DIESEL 2015 Service Manual page 50

9. Rotate the camshaft until the camshaft lobes are fac-
ing away from the rocker arms; then secure the
rocker arm support with the flat washers and nuts.
Tighten to 29 ft-lb.
10. Install the timing belt (see Left-Side Components in
this section).
11. Check adjustment of all valves (see Top-Side Com-
ponents in this section).
12. Place a small bead of high-temperature sealant on
both sides of the fuel rail seal; then carefully install
the valve cover with a new gasket and oil return
boot. Secure with existing hardware.
48
DE529
13. Using a crisscross pattern, tighten the Allen-head cap
screws to 6.5 ft-lb; then tighten the two "tamper-
proof" torx-head cap screws to 6.5 ft-lb.
14. Connect the fuel hoses to the fuel rail; then connect
the crankcase breather hose.
DE571
15. Connect the oil pressure switch connector to the oil
pressure switch.
DE260C
16. Install the air filter assembly; then remove the tape
from the engine air intake boot and connect the air
intake boot. Tighten the boot clamp securely.
17. Install the air diverter and connect the air boots.
Tighten the clamps securely.
18. Install the front body; then install the front rack (see
Steering/Frame/Controls).
DE451
DE295A
DE077B