Arctic Cat 700 DIESEL 2015 Service Manual page 49

5. Apply clean engine oil to the governor assembly and
install on the camshaft; then hold the flyweight
assembly and remove the rubber band. Install a new
O-ring on the camshaft.
DE278A
6. Using a new O-ring, install the camshaft support
housing and tighten the cap screws to 7 ft-lb.
DE531A
7. Install the camshaft drive pulley and cap screw; then
using a suitable holding tool, tighten the cap screw to
59 ft-lb.
DE535
If the cylinder head has been removed, no more compo-
nents may be installed prior to installation on the
engine block. If the cylinder head has not been
removed, proceed to step 8.
8. Lubricate all rocker shaft components with clean
engine oil; then install the rocker arm assembly on
the cylinder head making sure the injector push rods
are correctly installed in their respective injectors.
DE536
AT THIS POINT

DE537
DE245A
DE262
47