Arctic Cat 700 DIESEL 2015 Service Manual page 16

4. Remove the movable drive face using care to keep
the face plate tight against the drive face to prevent
the weights from falling out. Account for a spring
seat, spring, bushing, and lock washer.
5. Thread one of the V-belt cover screws into the fixed
driven face and turn clockwise to open the driven
pulley faces.
14
6. Push the V-belt down between the sheaves of the
driven pulley approximately one inch; then making
sure not to dislocate the one-way clutch from the
fixed drive hub, squeeze the belt together and
remove from the drive clutch.
DE093A
INSTALLING
1. Place the V-belt into position over the driven pulley
noting the directional arrows on the V-belt.
DE095
 NOTE: The diesel engine in this ATV rotates coun-
terclockwise as viewed from the right side; therefore,
if directional arrows are printed on the V-belt, they
must be directed rearward.
2. Push the V-belt down into the driven pulley approxi-
mately one inch; then squeeze the belt together and
slide over the fixed drive hub and onto the one-way
DE096A
clutch.
DE094A
DE098A
DE488
DE098A