Cylinder Head Assembly - Arctic Cat 700 DIESEL 2015 Service Manual

11. Install the valve cover using a new gasket and new
oil return boot. Tighten the Allen-head cap screws to
6.5 ft-lb using a crisscross pattern; then tighten the
"tamper-proof" cap screws to 6.5 ft-lb.

CYLINDER HEAD ASSEMBLY

AT THIS POINT

If the cylinder head or components require servicing,
the engine/transmission must be removed.
Removing
1. Remove the engine and transmission (see Removing
Engine/Transmission in this section).
2. Secure the engine on a suitable stand.
3. Remove the timing belt (see Left-Side Components
in this section).
4. Remove the unit injectors (see Top-Side Compo-
nents in this section).
5. Remove the lift pump and lift pump push rod (see
Fuel/Lubrication/Cooling).
6. Rotate the crankshaft to approximately 90° after top-
dead-center (ATDC).
DE534B
DE405A
7. Turn the camshaft drive pulley until the camshaft and
rocker arms are "unloaded" (all rocker arms in
"valve-closed" position).
Do not rotate camshaft with the crankshaft in the TDC
position or severe engine damage will occur.
8. Remove the three nuts securing the rocker arm shaft;
then using rubber bands or a large O-ring secure the
rocker arms together.
9. Lift the rocker arm assembly from the cylinder head.
Account for three washers.
CAUTION
DE240A
DE275A
DE307
57